PU Leather Clipboard w Metal Clip - White

This high quality sublimation clipboard comes with the metal clip to be attached after you sublimate onto your board. 

The one side is solid black textured, while the sublimation side is available in an assortment of colours. 

See other listings for additional colours. 

 TOOLS NEEDED:
a) Hammer
b) Solid Drill Bit Punch or Bolt with flat end (as wide in diameter as
the width of the rivet. find at your local hardware store)
-top rivet
MATERIALS PROVIDED:
c) Clipboard
d) Clip
) Rivet Sets (Top and Bottom Rivet for each hole)
bottom rivet
INSTRUCTIONS
e
Step 1: Place clipboard on a rigid work surface suitable for
hammering, and insert bottom rivets with shafts pointing up
through clipboard holes. Place clip on top of clipboard, lining
up the clip holes with the bottom rivets.
Step 2: Place a top rivet onto the bottom rivet shaft. Use the
hammer and drill bit punch (or bolt) to tap the rivet into place
(as shown above). Repeat with second rivet assemblv.
Step 3: Check back of clipboard to make sure back rivets are flat. Check clip to make sure it is secure. If there is any movement
try tapping the rivet assemblies with the hammer and drill bit punch again to set them more securely.
IMPORTANT: MAKE SURE CLIP IS TIGHTLY ATTACHED (NO WIGGLING). MAKE
SURE ALL RIVETS ARE FLAT TO CLIPBOARD SURFACE.